Introduction of Steps in the Foundation Repair Process
Important Point
Foundation contractors have been using the 5-step foundation repair process for years. You have to ask questions before hiring a contractor to fix your foundation, which might be costly.
It’s a good idea to research what the surgery comprises and the techniques for repair. The foundation repair technique we utilize is done in five steps for a reason, and it’s very prevalent in Texas.
The only time a repairman will enter your property is to inspect the final elevations unless you require inside foundation piers.
What Is the Step Foundation Repair Process?
Contractors in the Dallas, Fort Worth, and Arlington, TX areas utilize it to repair foundations. This method is carried out in a sequential manner.
A foundation repair contractor can reduce the cost of any repairs and ensure that the procedure is carried out correctly by employing this approach. Creating a structure level necessitates prior experience.
Because the price is always a factor, it’s a good idea to inquire about foundation repair charges. The cost of doing the procedure might be as little as $2,000 or as high as $10,000.
The cost of fixing some foundations can exceed $15,000 in extreme cases. On certain foundations, the five steps can be somewhat involved. This is why, prior to getting your foundation repaired, you should inquire about expenses.
When Performing Repairs Using This Method, Foundation Contractors Execute the Five Procedures Below:
- Examine your foundation for repairs:
- Give you lots a contractor quote for foundation repairs or any other contractor services that may be required as part of the project.
- If necessary, get a structural engineer’s report on your foundation as soon as feasible.
- Make repairs to the foundation of your home or business. You’ll want to learn more about Dallas, Fort Worth foundation repair companies that use a 5-step process.
- When the procedure is over, clean up the job site. Our system for repairing repairs is really effective.
What Steps Do Foundation Repair Contractors Take?
contractors prepare the job by putting down tarps, removing plants from around the foundation, and disconnecting specific utilities. There will be less mess if you do it this way.
Digging Holes Around the Foundation
As part of the fifth phase in conducting necessary foundation repairs, the contractor will dig holes around the perimeter of your foundation or, if interior piers are required, holes will be dug immediately underneath your house.
As practically every contractor will tell you, this will take some time. These actions necessitate having a contractor strip out the carpet on top of the foundation and tear apart pieces of your concrete slab foundation to perform these actions. This is done so that the piers can be installed before the foundation is fixed.
Putting the Foundation in Place
During this stage of the 5-step procedure, concrete or steel piers are erected. Our workers will need to enter your property if interior foundation piers are erected as part of the repairs.
The installation of exterior piers does not necessitate gaining access to your home. Contractors will gradually lift the structure. This necessitates the use of hydraulic jacks and concrete piers or steel piers installed beneath the foundation by the contractor.
The house is then placed on top of the foundation piers to provide stability. Steel shims may be installed under the foundation by your foundation repair contractor. The next stage of the procedure entails something else, but that’s all part of the house foundation repair process.
Covering Holes
During the fourth phase, the skilled team or contractor will ensure that all holes drilled under or around your foundation are covered with the soil that was previously removed.
Because the earth contracts when it rains or floods, after foundation restoration, the dirt around your foundation should be heaped higher than usual. This allows the dirt to gradually sink into the holes over time. It could take a year or longer to fully compress. Excess soil should not be a cause for concern.
After the repairs have been finished, clean up around the foundation by removing tarps and debris and restoring the plants that were previously removed. The process is complete once your specialist has completed all five phases included in the repairs.
How Does Foundation Repair Work?
Plan Development
The first step in foundation restoration is to devise a strategy. When a foundation repair professional inspects your home, they will usually devise a basic plan for where your home requires additional support in order to hold it up and return to its former position.
The repair plan will specify the sites where the support will be installed as well as the number of support locations required. The supports are usually found along a portion of the home’s perimeter.
Support positions are typically 7 feet apart, depending on the method, and run around the perimeter of the house. In roughly 10% of cases, you may also require support beneath the middle section of the house.
Support Installation
We discuss two basic types of support systems in this section because they are the most common in our Central Texas region.
The supports beneath your house are known as “underpinning” in engineering language. However, depending on the method utilized for foundation restoration, they are more usually referred to as “piers” or “pilings.”
These piers or pilings are tall and cylindrical, like columns on a beautiful plantation-style home’s front porch. Imagine your house being supported by stilts beneath it, but the stilts are underground.
In the case of piers, also known as bell-bottom piers, the supports are built underneath by digging and drilling, then pouring concrete. If using pilings, also known as pressed piles, hydraulic pressure is used to drive pre-formed concrete chunks into the ground.
Home Raising
The foundation repair contractor will then raise the sunken areas of the home and check that the foundation has been restored to its previous elevation after putting the supports in the ground.
The home is elevated using the pressed pile method by the tension of the pile in the ground pushing up on it. This is similar to how a spring holds a battery in place when you insert it into a device. The earth is represented by the spring, while the battery is represented by the compacted pile.
The house is elevated using jacks, kept in place by this spring-like tension, and shimmed to ensure proper height. As part of the bell bottom pier method, the support pier is used as a starting point for raising the home’s foundation.
As a result of the placement and use of hydraulic jacks, a home can be raised to its proper position. Shims are then hammered into place to secure the home’s elevation.
Stabilization
Some homes are not elevated back to their former position but are instead supported in their current position. In the short term, stabilizing a home might keep it from moving or sinking more.
When a home has already been remodeled with fine finishes that a homeowner wouldn’t want to damage, stabilization is preferred over elevating. It’s possible that the lifting process would cause damage to newly refinished walls, woodwork, cabinetry, or built-ins or worktops and backsplashes in a remodeled home.
As a result, everything was installed while the house wasn’t in the appropriate place. Consequently, moving the house will force all the finished work to be moved, which will result in further troubles and repairs for the homeowner.
Foundation Remediation
Unacceptable total or differential settlements are the most likely cause of foundation remediation. Small, private things, residential or commercial buildings, or infrastructure objects are not exempt from the problem and should be given more attention.
Caused by a Number of Factors, Including:
- Exceeding the Permitted Stress Limit
- Excessive Foundation Settlement
- Changes in Groundwater Flow
- Stormwater Effects
- Consolidation Settling;
- Undercutting the Foundation
- Change in a Static System
Commonly Used Foundation Remediation Technologies Are:
- Foundation Remediation by Concrete Underpinning
- Foundation Remediation with Jet Grouting
- Foundation Remediation with Micro Piles
- Foundation Remediation by Using Expanding Geopolymers
Foundation Stabilization Methods
Steel Piers
Most structural experts will recommend this foundation repair for your property. This is a tried-and-true way of repairing a foundation that has begun to shift or sink into shaky ground.
Large galvanized or epoxy-coated steel pipes are linked together in this way. The steel piers will be driven deep into the stable, load-bearing earth beneath your home by a structural engineer using a hydraulic ram. To avoid further settlement, this foundation repair will lift and support your home.
Helical: Steel Piers
Steel pipes having spiral blades on the bottom ends are known as helical steel piers. One or more helixes (spirals) are affixed to the pipe’s front part.
This will provide the steel pipes with the required bearing capacity. The piles will be twisted into the earth with a hydraulic torque motor in this sort of foundation rehabilitation. Because of the helixes on the lower ends of the steel pipes, they do not need to be as deep as driven piers.
Concrete Press Piles
These are prefabricated concrete columns that are inserted into the ground beneath the existing foundation. These are far faster to install than the other options we’ll cover in this article.
They can be utilized right away after they’ve been installed. They do not require the same amount of time to harden as poured concrete piers. They are not, however, attached to the home’s foundation, unlike steel piers.
This increases the likelihood of the concrete piles shifting over time. You’ll save money for now, but only time will tell whether you’ll have to pay for another foundation repair in the future.
Concrete Piers
Concrete piers are constructed by pouring concrete into holes drilled beneath the home’s existing foundation. This foundation restoration method is messier and more labor-intensive than the others.
To complete a proper installation, the process takes about three weeks. It takes time for the concrete to harden properly, and nothing can obstruct this process.
After the concrete piers have hardened, the house is lowered onto them. This strategy makes determining when these piers have reached the load-bearing ground beneath the foundation extremely challenging.
Mudjacking
This is a type of concrete restoration that is commonly used to raise minor concrete layouts. This is used to raise things like sidewalks, garages, and basement floors, among other things.
Drilling holes in the existing concrete slab and pouring a concrete mixture underneath to provide another level of stabilization is how this is done.
This is not a method for repairing a house foundation. You should call another firm if a foundation repair specialist recommends this as a cheap option.
While this procedure works well for minor concrete layouts, it is not suggested for foundation rehabilitation.
Frequently Asked Questions (FAQ)
What Are the Signs That My Foundation Needs Repair?
Common signs include cracks in walls or floors, uneven floors, doors or windows that stick or don’t close properly, gaps between walls and ceilings, and visible sinking or settling of the foundation.
How Long Does Foundation Repair Take?
The duration of foundation repair depends on various factors such as the extent of damage, the type of repair needed, and the size of the property. It can range from a few days to several weeks.
What Causes Foundation Problems?
Foundation problems can be caused by factors such as soil movement (expansion or contraction), poor drainage, plumbing leaks, tree roots, improper construction, and natural disasters like earthquakes or floods.
Can Foundation Issues Be Fixed Without Major Construction?
Yes, minor foundation issues can often be addressed with repairs such as crack sealing, leveling, or installing additional supports. However, more severe problems may require significant construction work like underpinning or pier installation.
How Much Does Foundation Repair Cost?
The cost of foundation repair varies widely depending on the extent of damage, the repair methods used, and the contractor’s rates. It’s essential to get quotes from multiple contractors and understand the scope of work before proceeding.
Will Foundation Repair Increase the Value of My Home?
Fixing foundation issues can improve the structural integrity and overall condition of your home, which can positively impact its value. However, the exact increase in value depends on various factors such as market conditions and the quality of repairs.
Like this post? Share it with your friends!
Suggested Read –
- How to Fill Foundation Crack?
- How to Fix a Settling Foundation?
- About Our Foundation Repair Methods
- How Do I Water My Foundation Correctly?
- How Does Installing a French Drain Around Foundations Prevent Damage?
Leave a Reply